ROCKER ONLY-

• This is just the top part of the switch and is purchased if you already have switches and need to either replace the existing rockers or have purchased switch bodies elsewhere.

________________________________________________________________________

V1D1BC0B -SPST OFF/ON – Red LED

V1D1BN0B-SPST OFF/ON – Amber LED

• Upper LED that is ON when the switch is turned ON.
• Three terminal switch with no rear barriers.  Use 1/4" female disconnects or VCH housing. (Packard terminals for the rear housing are sold separately)

________________________________________________________________________

V1D1JHNB- SPST OFF/ON – Green upper, amber lower LED

V1D1JCNB- SPST OFF/ON – Red upper, amber lower LED

• Upper LED is ON when the switch is turned ON.
• Lower LED is independently wired.
• Each LED has its own ground terminal.
• Five terminal switch with no rear barriers between terminals
• Use insulated 1/4" female disconnects or the VCH rear connector housing.  (Packard terminals for the rear housing are sold separately)
• This switch has the same terminal layout and lighting configuration used by ARB

_______________________________________________________________________

V1D1FHNB- SPST OFF/ON –Green upper, amber lower LED

V1D1FCTB- SPST OFF/ON- Red upper, daylight bright red lower LED

V1D1FNTB- SPST OFF/ON- Amber upper, daylight bright red lower LED

V1D1FBBB- SPST OFF/ON- Blue upper and lower LED.  These LEDs are bright and consideration should be given on where you plan to install the switches as they might be a distraction at night.  Not recommended for pillar or above the windshield switch panels.

• Upper LED is independently wired.
• Lower LED is ON when the switch is turned ON.
• Each LED has its own ground terminal.
• Five terminal switch with no rear barriers between terminals
• Use insulated 1/4" female disconnects or the VCH rear connector housing.  (Packard terminals for the rear housing are sold separately)

_______________________________________________________________________
  

V6D2UHNB – SPDT ON/OFF/ON –

• Green upper LED
• Amber lower LED
• Both LEDs are independently wired and have separate ground terminals. 
• This switch could be installed upside down to place the amber LED at top, green LED at the bottom
• Seven terminal switch with no rear barriers between the terminals
• Use insulated ¼” female disconnects or the VC1-01 connector housing (Packard terminals for the rear housing are sold separately)
Verify that a SPDT switch is suitable for your application prior to purchasing this switch.  If a DPDT switch is required use the VJD2UHTB or similar VJD model switch.

 

Switch Specifications:

• 12 volt switches are rated 20 amps. 
• 24 volt versions are rated 15 amps.
• Panel cutout required is .830 by 1.45 inches

Detailed specifications are located here:

http://www.carlingtech.com/pdf/CarlingSW_V2_3.pdf