ROCKER ONLY-

• This is just the top part of the switch and is purchased if you already have switches and need to either replace the existing rockers or have purchased switch bodies elsewhere.

V1D1BC0B -SPST OFF/ON -

• Standard red upper LED that is ON when the switch is turned ON.
• Three terminal switch with no rear barriers.  Use 1/4" female disconnects or VCH housing. (Packard terminals for the rear housing are sold separately)

V1D1GHTB -SPST OFF/ON -

• Green upper LED is independently wired
• Red super bright lower LED is ON when the switch is turned ON
• Four Terminal switch with no rear barriers between the terminals. 
• Use insulated 1/4" female disconnects or the VCH rear connector housing.  (Packard terminals for the rear housing are sold separately)

V1D1JHNB- SPST OFF/ON -

• Green upper LED is ON when the switch is turned ON.
• Amber lower LED is independently wired.
• Each LED has it's own ground terminal.
• Five terminal switch with no rear barriers between terminals
• Use insulated 1/4" female disconnects or the VCH rear connector housing.  (Packard terminals for the rear housing are sold separately)
• This switch has the same terminal layout and lighting configuration used by ARB

V1D1FHNB- SPST OFF/ON -

• Green upper LED is independently wired.
• Amber lower LED is ON when the switch is turned ON.
• Each LED has it's own ground terminal.
• Five terminal switch with no rear barriers between terminals
• Use insulated 1/4" female disconnects or the VCH rear connector housing.  (Packard terminals for the rear housing are sold separately)
   

VDD2NNB -DPDT ON/ON -

• Both amber LEDs are independently wired
• Each LED has it's own ground terminals.
• Ten terminal switch with no rear barriers between terminals
• Use insulated 1/4" female disconnects or the VC1-01 connector housing (Packard terminals for the rear housing are sold separately).

V6D2UHNB – SPDT ON/OFF/ON –

• Green upper LED
• Amber lower LED
• Both LEDs are independently wired and have separate ground terminals. 
• This switch could be installed upside down to place the amber LED at top, green LED at the bottom
• Seven terminal switch with no rear barriers between the terminals
• Use insulated ¼” female disconnects or the VC1-01 connector housing (Packard terminals for the rear housing are sold separately)
• Verify that a SPDT switch is suitable for your application prior to purchasing this switch.  If a DPDT switch is required use the VJD2UHTB or similar VJD model switch.

Switch Specifications:

• 12 volt switches are rated 20 amps. 
• 24 volt versions are rated 15 amps.
• Panel cutout required is .830 by 1.45 inches

Detailed specifications are located here:

http://www.carlingtech.com/pdf/CarlingSW_V2_3.pdf